您好！欢迎来到工业毛刷制造专家-欧舟工业（昆山）有限公司网站！

Centerless Grinder Brushes: For use with through-feed centerless grinders (Cincinnatti No. 2 and 3, Landis No. 5, and Hammond), in place of a grinding wheel. Typical applications include removal of sharp edges, feather burrs, surface finishing, surface preparation for plating, and removal of rust stains and discoloration from heat treating. Standard outer diameter is 20″. Brush face widths range from 3 ½” to 10″ wide. Inside diameter is 12″. A choice is offered between the standard core or a closer tolerance machined core. Available fill materials include carbon steel wire, stainless steel wire, tampico, and abrasive nylon. Brushes can be filled with a combination of coarse and fine abrasive filament to perform two stages of finishing in one pass. Other sizes are available on special order to meet the requirements of a specific centerless grinder.